Messages

1

General discussion about BabaCAD / Re: Copy, Array and Mirror Commands.

« on: June 06, 2017, 04:46:05 pm »

Thank you for the quick response.
Yesterday forgot to comment that codes 10 and 11, usually associated with the beginning and end of a line, appear as 10 and 10, is it on purpose ?. In the DXF file, codes 10,20 and 30 and 11, 21 and 31 for x, y and z appear at the start and end of the line. If that's the case, I would only change the way I access those codes through lisp programs.
I can not wait for the next version.
Keep going.

2

General discussion about BabaCAD / Copy, Array and Mirror Commands.

« on: June 05, 2017, 05:53:30 pm »

First of all, I want to congratulate you for the time and effort put into Babacad software development.
Testing some commands, I realized that (at least in my case), the copy command only reaches the part where it asks for the source point to copy and stops; in the case of the array and mirror commands, those come to the end, but do not regenerate the "Z" coordinate.
Trying to program my own "Copy" code, I have access to entities with (entget (cdr (entsel))) and I realized that I do not get that coordinate with code even the properties bar shows that if there are (coordinates " Z ").
I wonder if this is the reason why the commands are not executed correctly.