1
General discussion about BabaCAD / Re: Beginners question
« on: October 31, 2014, 10:11:20 pm »
Hey thanks a lot. The @ seems to be the key I was looking for. I can go back to the baba designing desk now. 
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
General discussion about BabaCAD / Beginners question
« on: October 30, 2014, 12:05:38 pm »
Hi,
I found babaCAD after reading http://www.zdnet.be/article/158615/ontwerp-je-eigen-technische-tekeningen/
I try to use babaCAD for designing a furniture project that I would like to build. It is the first time I work with this kind f software. My whole thinking is based on distances and measurements. I find it difficult in let's say putting an object a certain distance from another object. Or resizing an object to new measurements (eg: rezising a block to 30 x 800) . It looks like everything is based on coordinates which makes it complicated to me.
Can someone give me a hint where to look, or how to work with measurements ?
Thank you very much for reading this.
Dirk
I found babaCAD after reading http://www.zdnet.be/article/158615/ontwerp-je-eigen-technische-tekeningen/
I try to use babaCAD for designing a furniture project that I would like to build. It is the first time I work with this kind f software. My whole thinking is based on distances and measurements. I find it difficult in let's say putting an object a certain distance from another object. Or resizing an object to new measurements (eg: rezising a block to 30 x 800) . It looks like everything is based on coordinates which makes it complicated to me.
Can someone give me a hint where to look, or how to work with measurements ?
Thank you very much for reading this.
Dirk
Pages: [1]